Garage door openers installation is a relatively straightforward project, but the installation process is too detailed. That is why, you should do garage door openers installation based on the manufacturer’s instructions for detailed, step-by-step procedures.
Before you start to do garage door openers installation, there are a few materials and tools which you must assemble in one place. Apart from the garage door opener, you must have a mounting bracket, lag screws, some 2″ X 4″ pieces, shims and insulated staples. Also, you should prepare the following tools handy: screw drivers, wrenches, a drill, drill bits, a socket set, wire cutter, a pair of pliers, a hammer, a tape measure, a hacksaw, level, and a step ladder. You should also make sure that you have a grounded receptacle (a ground fault circuit interrupter outlet) which is close to the garage door opener.
Then, make sure that the door tension is correct. To test this, open the door about half way, and let go. If the door stays in position, then the spring tension is correct. If not, you should then get this fixed before you begin doing garage door openers installation.
Before doing garage door openers installation, you should also take a look at your garage door. Is it an ancient behemoth or one of the relatively lightly built units made in recent years? If the former, be sure to advise the salesman you are dealing with, because you may require a heavier duty unit than what he may assume.
You should also test the operation of your door before doing garage door openers installation. If you raise the door to chest height, does it plunge heavily to the floor? If so, beware. In this case, you are probably better off to consult an expert.
Also, check that the door goes up and down smoothly. If it does not, your rails may be out of adjustment. If the springs are not properly adjusted or the rails are out of alignment, you will risk imposing an unacceptable load on your garage door opener, leading to premature failure, if not a potential disaster.
Actually, a professional can do garage door openers installation for you. However, he certainly does it for a fee. If you are an experienced do-it-yourselfer, you can actually handle the installation by yourself.
If you are confident in your abilities, just go ahead and do garage door openers installation right now. Begin by inventorying the parts and reading and comprehending the manual completely. If you find yourself scratching your head about the installation, call customer service and see if they can illuminate you.
Regardless of the type of garage door opener you will be installing, special safety rules will apply. During the procedure of garage door openers installation, you should not wear rings, watches or loose clothing. Also, you should remove all ropes connected to the garage door prior to installing the opener and disengage all existing garage door locks to avoid damage to garage door.
In doing garage door openers installation, you should remember that lightweight garage doors require reinforcement with a 2 x 4 board at least 6 feet in length, and installation and wiring must be in compliance with local building and electrical codes. Do not use force to compensate for a binding or sticking garage door. This will interfere with the proper operation of the safety reverse system and possibly damage the garage door.
In addition, to do garage door openers installation, you need to fasten the caution label on the wall near the wall control as a reminder of safe operating procedures. You also need to install all controls out of the reach of children. And, the most important thing that you should do is to adjust the opener properly.
Comments on this entry are closed.